Now the market demand of self feeding mixer is very large, many people who buy mixer are not very clear about the maintenance of newly purchased mixer. The maintenance of self feeding mixer is still very important. Careful maintenance can effectively extend the service life of mixer. The engine plays an important role in the self feeding mixer. The power source of the mixer depends on the engine, so we focus on the maintenance of the mixer engine.
The first is running in. All new cars have a running in period. Running in is the basis for extending the service life of self loading mixer. It must be run in according to the instructions. Oil purification, water purification, gas purification and body purification. Diesel is the main fuel of the mixer engine. If the diesel is not pure, it will make the precise matching body run in, increase the matching clearance, cause oil leakage, oil dripping, reduce the fuel supply pressure, increase the clearance, and even cause serious faults such as oil blockage, axle burning and so on.
If there is a lot of dust in the air, it will accelerate the wear of cylinder liner, piston and piston ring. If the cooling water is not pure, it will block the scale of the cooling system, hinder the engine heat dissipation, poor lubrication conditions and serious wear of the engine body. If the body surface is not clean, the surface will be corroded and the service life will be shortened. If the supply of diesel and air is not timely or interrupted, it will be difficult to start, poor combustion, power decline, engine can not run normally and so on. If the cooling water supply is insufficient, the temperature of the machine will be too high, the power will be reduced, the wear will be intensified, and the service life will be reduced.
Check the fastening parts frequently
Self feeding mixer. Due to the impact of vibration and uneven load during the use of diesel engine, bolts and nuts are easy to loosen. There are all parts of the adjustment bolts to check, so as not to cause loose and damage to the body accident.
Check and adjust
The valve clearance, valve timing, common advance angle, injection pressure and ignition timing of diesel engine should be checked and adjusted in time to ensure that the engine is always in good technical condition, so as to save fuel and prolong service life.
Correct use of engine
Before the feeding mixer runs, the bearing shaft and other lubrication parts should be lubricated. After start-up, it should be put into operation when the water temperature reaches 40 ℃ - 50 ℃. Long time overload or low speed operation is strictly prohibited. Before shutdown, the load should be removed to reduce the speed.
This article is from: Zhongke mixer. For more information, please click: http://www.govcov.com We will provide a satisfactory service for your questions, welcome your call!