1、 What is a mixer tug for?
The mixing truck tugboat is a bearing, which is used to support the tank. It is integrated with the mixer to assist mixing.
2、 How to change oil for hydraulic pump of mixer truck?
Generally, it is not recommended to replace it by yourself, but go directly to the after-sales point to find professional personnel for replacement. Moreover, the oil used must meet the requirements, otherwise the equipment will be greatly damaged and the service life will be greatly shortened. Therefore, the hydraulic oil with reasonable label should be replaced.
Seven common sense that you should know about mixing truck
3、 What is the relationship between the tank filling rate and the inclination angle of cement mixer truck?
At present, the inclination angle of mixer truck is about 12 degrees, and the filling rate is about 63%. The inclination angle is not easy to measure and the filling rate is difficult to calculate. At present, the sales of mixer truck are based on the effective mixing volume.
4、 What is the reason why the tank of the concrete mixer doesn't rotate and the hydraulic oil sprays out from the fuel port of the oil tank?
The hydraulic pressure enters and returns one by one. The inlet force may be due to the broken sealing part of the oil pump. Return oil flush, it may be that the oil pump sealing foot pad is broken, you can change a foot pad to try.
5、 What is the rotational speed of the mixing bucket of the concrete mixer truck?
The rotational speed of the mixing drum during feeding is 6-10 rpm, while that of the mixing drum is 6-10 rpm.
6、 What is the distance between the feeding port and the ground of 8-12 m3 concrete mixer truck?
Generally, the vehicle height of 8-12 square meters mixer is about 3.8 meters, and the distance between the feed inlet and the ground is about 3.5 meters, depending on different models.
7、 How to clean the tank of cement mixer?
The water tank equipped with the mixer truck should put the water into the tank after unloading each time. When returning to the tank, the water should be discharged to the mixing station to receive materials. The surface of the tank should be cleaned when the water tank is filled with water. Of course, it can also be directly cleaned with water in the water tank. If the cement slurry has solidified, find a professional cleaning tank inside the tank, and brush the surface with oxalic acid.